These Hard angled risers from Bear not only limit wheel bite, but create an improved turning radius for a better carve.
- Set of 2 Risers
Hardware Compatibility Explained - Longer bolts are needed to accommodate the addition of risers. Deck thickness is another factor in this. Reference the chart below to find out what length hardware your setup will require. These are the suggested standard, you can go longer, just don't go shorter.
|Size||1/4in - 1/8in|
|Hardware Length for Standard 7-Ply Decks (in):||1 1/4 - 1 1/2|
|Hardware Length for Thicker 8/9-Ply Decks (in):||1 1/2 - 2|